Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ActiveYards Bathroom Remodeling: The Campbell Owner’s Guide
ActiveYards bathroom remodeling in Campbell typically runs $9,000-$28,000 for a full renovation, with smaller refreshes starting around $5,000. We stock and install ActiveYards-compatible enclosures, hardware, and finishing systems, and we can usually get a crew to your property within a few business days once the written scope is signed. Most Campbell owners realize something’s off when the enclosure frame starts weeping at the corners, the door drags on the threshold, or they spot corrosion blooming where the aluminum meets the tile.
Which ActiveYards Models This Applies To
ActiveYards builds three main enclosure series that show up in Campbell bathrooms: the Regency semi-frameless line, the Avant framed series, and the occasional Legacy custom-order unit from the early 2010s. The critical compatibility gotcha is the wall-channel depth: Regency uses a 1-1/4 inch capture channel, while Avant runs 7/8 inch, and swapping hardware between them leaves you with a gap that caulking won’t fix long-term. Check the etched logo on the door hinge or the sticker residue on the header rail; if that’s gone, measure the channel depth with a tape measure before ordering anything.
We source OEM ActiveYards hardware through their West Coast distributor, but we’ve also vetted two aftermarket equivalents that match the anodized finish and roller bearing spec. The aftermarket saves roughly 15% on parts, though we disclose the origin in writing so you know exactly what’s going on your wall. For Campbell’s hard water conditions, we generally recommend the OEM roller assemblies; the cheaper ones tend to gum up inside 18 months.
Signs Your ActiveYards Bathroom Remodeling Is Failing

- Door drag or catch on the threshold. The nylon rollers have flattened or the axle pin has corroded in Campbell’s mineral-heavy water. Left alone, this stresses the header rail and turns a $90 roller swap into a $400 rail replacement.
- Water pooling outside the enclosure after every shower. The sweep gasket has hardened or the magnetic seal has lost its flex. We see this most in west Campbell homes near the reservoir, where the water treatment plant’s output runs harder than the city average.
- Corrosion at the wall-channel joints. Aluminum and steel fasteners react over time, especially where ventilation is poor. The white crusty buildup is aluminum oxide; once it starts, the channel wall is compromised and needs full replacement.
- Glass panel shifting or rattle. The stabilizer clips have fatigued or the silicone bedding has detached. This is the one to catch early: a 3/8-inch tempered panel that shifts far enough can contact the tile edge and chip.
- Finish fading or chalking on the frame. The anodized layer has broken down, usually from abrasive cleaners or, in hillside Campbell homes, UV exposure through a skylight. Re-anodizing in place isn’t practical; frame replacement is the fix.
Before
AfterReplacement Cost & What’s Included
For Campbell, here’s how ActiveYards bathroom work breaks down:
| Scope | Price Range |
|---|---|
| Full bathroom remodel (ActiveYards enclosure + fixtures + tile) | $9,000 - $28,000 |
| Small bathroom refresh (enclosure swap, vanity, floor) | $5,000 - $12,000 |
| Walk-in shower installation (ActiveYards base + glass) | $4,500 - $12,000 |
| Tub-to-shower conversion | $3,500 - $10,000 |
| Shower replacement (enclosure only) | $3,000 - $8,500 |
| Vanity installation | $800 - $3,000 |
The wide spread on full remodels comes down to three things: whether we’re moving plumbing (add $2,500-$4,000), the tile grade you select, and whether Campbell’s building department wants a permit for the scope. Under Clause 1 of the Haven Standard, we put the full number in writing before anyone picks up a tool, and no change moves forward without a signed change order. Every job carries our 365-Day Done Right Promise.
DIY or Call Us?

There’s a safe middle ground here. A homeowner can replace a door sweep, clean the roller track, or swap a handle set without much risk. Where DIY goes wrong is the enclosure removal itself: the glass panels weigh 80-120 pounds each, the wall channels are often silicone-bonded to cement board that tears if rushed, and Campbell’s older homes near downtown have plaster-and-lath walls that don’t forgive a misplaced pry bar. We’ve been called in twice this year to fix a DIY removal that cracked the pan liner and flooded the subfloor. If you’re past the point of cleaning and adjusting, call (831) 704-1211 and we’ll scope it properly.
FAQs
In Campbell’s climate, a properly installed ActiveYards enclosure lasts 15-20 years if the water is softened and ventilation is adequate. Without a softener, the roller bearings and sweep gaskets typically need attention at year 8-10. Call (831) 704-1211 for an exact quote on your unit - estimates are free.
Hardware failures - rollers, sweeps, handles, hinges - can almost always be repaired. Frame corrosion, glass damage, or pan failure means replacement. We document the condition with photos before recommending either path. Call (831) 704-1211 for an exact quote - estimates are free.
A full remodel runs 10-15 business days from demolition to final walkthrough, assuming Campbell permits clear on schedule. A simple enclosure swap is 1-2 days. We provide a written timeline with the price before work starts. Call (831) 704-1211 to schedule your free estimate.
We carry the common failure items: roller assemblies, sweep kits, magnetic seals, and stabilizer clips. Custom glass or frame sections ship from the distributor in 5-7 business days. We’ll tell you exactly what’s in stock before we schedule. Call (831) 704-1211 to check availability for your model.
Rowan Construction Group Campbell is an independent service provider and is not affiliated with ActiveYards. We also stock and install parts for KraftMaid, Cambria, and Silestone products.
Measure twice, document once, build it right. That’s how we’ve kept projects within a few percent of the agreed price across 4,000-plus jobs since 2007.
Written by Grant Rowan, Owner, Rowan Construction Group Campbell at Rowan Construction Group Campbell, serving Campbell and nearby areas.







Before
After
Before
After
Before
After